Pre-Polished Field Terminations
Swift and Simple - Fibre Terminations Fast
The Opticreach Field-installable Connectors make onsite Fibre Optic terminations Swift, Simple and High quality. Once Prepared the Fibre is simply inserted into the connector, a sliding latch is then activated to clamp the fibre in place.
Because this termination process is so Swift and Simple Opticreach connectors bring these Features and Benifits...
- No proprietary tools are required to terminate the fibre
- Low cost Preperation and cleave Kits
- Installation planning and set-up times are greatly reduced
- Installer Training is especially Simple
- Eliminates Wasted consumable such as Epoxies and Films
- Factory Polished Quality endfaces
- re-terminate up to five (5) times Eliminating Waste
All it takes is three simple steps to field terminate a fibre....
- Step 1 - Once the Jacketed fiber is stripped and cleaved for installation, insert the fiber into the connector
- Step 2 – Simply slide the connector’s clamping latch toward the front of the connector
- Step 3 – Close the Boot and fix the Boot to the rear of the connector
- Step 4 – Snap on SC Body
Swift and Simple fibre termination, Watch it Here !
Ordering Information
Product Types:
Swift Pre-Polished Fibre Optic Connectors
Description
Part Number
Swift Pre-Polished Fibre Optic Connector, Singlemode, 2-3mm Aramid Yarn Clamp
SWF-FAC-USC-3MM